IB-E03 2 Zone Controller (4 Amp) – Cable Not Included
Models Applicable
PM486FS, PM486FE, PM486FP, PM605FE, PM635FS
- Controls up to 2 Power Mollers – Brake and non-brake models*
- Custom programmable ladder logic for fine tuning your specific application
- EtherNet/IP CONFORMANCE TESTED™
- Device Level Ring (DLR) technology built in
- Control, Monitor and Diagnose the performance of each motorized roller that is connected
- 2 port Ethernet switch built upon Rockwell Automation’s switch technology
- I/O device equipping 3 discrete inputs and 5 discrete outputs
- UL and cUL recognized component
- Direct connection for 2 photo sensors that power and receive the output signal
- LED status / error indicators
- Motor pulse counting through local logic
- Connects to EtherNet/IP controllers(PLCs) through an I/O connection(implicit messaging)
- Establish I/O connection to Rockwell Automation’s software and control platforms through E/IP
Protection
- Thermal overload 203°F (95ºC) for the drivers
- Thermal overload 221ºF (105ºC) in the motor
- 7.0 A fuse for each motor
- Input Power Protected from reverse polarity
Environment
- Ambient Temperature: 4~104º F (-20~40ºC)
- < 90% Relative Humidity
- (No condensation)
- No Corrosive Gases
- Vibration < 1.0G
Connectors
Motor Power [CN1] WAGO 231-302 / 026-000
Communication [CN404 & CN405] RJ45
Sensor [CN303 & CN304] WAGO 733-104
External input [CN301] WAGO 734-204
Signal output [CN302] WAGO 734-206
